Automatic Control 31Nm 10KW Eddy Current Dynamometer

SECD10-3000/15000 easy operation eddy current dynamometer

Principle of operation

When the current flow through the field coils, then magnetic field is produced. If the toothed rotar is rotated in the field, the magnetic flux changes and eddy current are produced in the end wall of cooling plate. These Eddy Currents buildup an opposite magnetic field and decelerate the rotar. The braking torque is transfered via the bearing mounted body to the load cell. The dynamomemter load is regulated by changing the excitation current. Energising Coils: The coils are fully encapsulated in two pieces. These are insulated from the main body with high quality insulating material. This gives very optimum distribution of flux throughout the working area. Because of this in case of low speed torque it gives best results of air flow from the center of dyanometer. This features ensures rapid response of reliability under the serveral loading conditions. Control: The power absorbed by the dynamomemter is controlled by varying the energising current at the field coil. System is provided with Closed Loop Control by giving feedback signal from Load Cell for Torque & from RPM Sensor for Speed. Both & Automatic Control Systems are provided along with PC based Data Acqusition & Control System.

Product picture

Characteristic curve

Technical parameters

Product discribtion

• Small size, easy installation;

• Simple structure, easy operation and maintenance;

Typical application

• Eddy current dynamometer is mainly used in motors, gearboxes,Engine, actuator, traction machine, drill pipe, hydraulic wrench, slewing ring .

10KW Eddy Current Dynamometer

Automatic Eddy Current Dynamometer

Automatic Control 31Nm 10KW Eddy Current Dynamometer Images